Specification of Elastomeric Rubber Bridge SIGTECH 550*450*58 mm
Supplier of Elastomeric Rubber Bridges
The use of elastomeric rubber as a bearing for bridge girders is common in Indonesia. This component plays an important role in stabilizing the bridge structure from various movements. We provide complete size variants, one of which is as follows:
- Length: 550 mm
- Width: 450 mm
- Height: 58 mm
- Warranty: 3 years
- Max Load: 191 tons
- Base material: natural rubber (NR), Chloroprene (CR)
- Standardization: SNI and AASHTO
In general, elastomeric rubber or bridge bearing rubber is installed for loads from the top of the bridge that is being crossed by the load to the bridge piers so that there is no direct friction or collision between the super bridge structure and the bridge sub structure.
This Rubber Bearing as a bridge support, between the girder and the abutment reduces friction and vibration caused by bridge loads and other movements.
Bearing Pad Types:
1. Laminated Elastomeric Bridge Bearings
2. Laminated Bearings
3. Lead Rubber Bearings
4. Pot Bearings
5. Base Isolation Bearings
Advantages:
1. 3 years warranty
2.AASHTO (American Association of State Highway and Transportation Officials) standardized
3. SNI 1967-2008
4. Natural rubber (NR), Chloroprene (CR)
5. Size and spec can be custom as needed
6. Can be applied in buildings and bridges
7. Pass the test at the Rubber Research Center (Indonesia Rubber Research Institute)
