Specification of Elastomeric Bearing Rubber SIGTECH 650*350*65 mm
Sell SIGTECH Elastomeric Bearing Rubber
The use of rubber bearing girders is common in Indonesia. It is a very important component in stabilizing the bridge structure from various risks of movement and shifting that may occur. There are various sizes available, one of which is as follows:
- Length: 650 mm
- Width: 350 mm
- Height: 65 mm
- Warranty: 3 years
- Max Load: 175 tons
- Base material: natural rubber (NR), Chloroprene (CR)
- Standardization: SNI and AASHTO
Widely known as the elastomeric bering pad, this component is designed as the main support for the girder with the lower supporting concrete in the construction of a bridge construction that functions to withstand pressure or loads on the bridge. It plays an important role as a load channel from the top of the bridge that is being crossed by the load to the piers of the bridge so that there is no direct friction or collision between the super bridge structure and the bridge sub structure.
This Rubber Bearing as a bridge support, between the girder and the abutment reduces friction and vibration caused by bridge loads and other movements.
Bearing Pad Types:
1. Laminated Elastomeric Bridge Bearings
2. Laminated Bearings
3. Lead Rubber Bearings
4. Pot Bearings
5. Base Isolation Bearings
Advantages:
1. 3 years warranty
2.AASHTO (American Association of State Highway and Transportation Officials) standardized
3. SNI 1967-2008
4. Natural rubber (NR), Chloroprene (CR)
5. Size and spec can be custom as needed
6. Can be applied in buildings and bridges
7. Pass the test at the Rubber Research Center (Indonesia Rubber Research Institute)
